GarrettCom Magnum 700X Network Router User Manual


 
Magnum 700X Mini-Concentrators Installation and User Guide (05/98)
GARRETT
25
Slowly and firmly push the
PM into position. Once
inserted, secure the PM card
using the two screws on the
front panel of the unit. Once all
PM cards needed have been
installed (including face plates
for empty slots), replace the
chassis cover.
NOTE:
All PM slots need not be filled in order for the unit to be operational. When
leaving PM slots empty, always use a face plate (Magnum PM-FP) to cover the
opening in the front panel to keep the unit clean, and for safety.
3.5 Removing PM Cards
To properly remove a PM card from the Magnum 700X Mini-Concentrator, follow the
steps below.
1. Removing 700X Chassis Cover and PM Retaining Screws
Follow the procedure described for Face Plates in Section 3.3, Steps 1 and 2, above.
2. Removing PM Card
Gently pull the PM card up and out of the connector socket. If the slot from which the
PM card has been removed is to remain open be sure to install an PM face plate. If another
PM card is replacing the one that
has been removed, follow the steps
as described for installing an PM
card discussed on the preceding
pages.
NOTE:
Use a face plate
(Magnum PM-FP) to cover the opening
in the front panel if you are leaving any
700X Mini-Concentrator slots empty.
PM Cards
Magnum 700X
Magnum 700X Mini-Concentrator
PM Card
Magnum 700X
Magnum 700X Mini-Concentrator