Filter
Top Products
www.gateway.com
57
8 Reconnect the power cords and turn on the server. The BIOS is reset.
9 Turn off the server, then disconnect the power cords and all other cables connected to
the server.
10 Follow the instructions in “Opening the server case” on page 25.
11 Place the jumper back onto pins 1-2.
12 Follow the instructions in “Closing the server case” on page 27.
Resetting BIOS passwords
To reset BIOS passwords, you must either reset and clear all BIOS settings, or use the Clear
Password jumper. To reset all BIOS settings, follow the instructions in “Resetting the BIOS” on
page 56.
To clear the BIOS password(s):
1 Follow the instructions in “Preventing static electricity discharge” on page 24. Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
2 Follow the instructions in “Opening the server case” on page 25.
3 Remove the jumper across pins 1-2 of header J56-A, then place the jumper across pins 2-3.
4 Follow the instructions in “Closing the server case” on page 27.
5 Reconnect the power cords and turn on the server. The BIOS password(s) is cleared.
6 Turn off the server, then disconnect the power cords and all other cables connected to
the server.
7 Follow the instructions in “Opening the server case” on page 25.
8 Place the jumper back onto pins 1-2.
9 Follow the instructions in “Closing the server case” on page 27.
Caution
Moving the jumper while the power is on can damage your server. Always turn off
the server and unplug the power cords and all other cables before changing the jumper.