Filter
Top Products
CHAPTER 6: Troubleshooting
64
Drive Not Ready
The BIOS was unable to access the drive because it indicated it was not ready for data transfer.
This is often reported by drives when no media is present.
A: Drive Error
The BIOS attempted to configure the A: drive during POST, but was unable to correctly configure
the device. This may be due to a bad cable or faulty diskette drive.
Insert BOOT diskette in A:
The BIOS attempted to boot from the A: drive, but could not find a correct boot diskette.
Reboot and Select proper Boot device or Insert Boot Media in selected Boot device
BIOS could not find a bootable device in the system or removable media drive does not contain
media.
NO ROM BASIC
This message occurs on some systems when no bootable device can be detected.
Storage Device messages
Primary Master Hard Disk Error
The IDE/ATAPI device configured as Primary Master could not be correctly initialized by the BIOS.
This message is typically displayed when the BIOS is trying to detect and configure IDE/ATAPI
devices in POST.
Primary Slave Hard Disk Error
The ATAPI device configured as Primary Slave could not be correctly initialized by the BIOS. This
message is typically displayed when the BIOS is trying to detect and configure ATAPI devices in
POST.
Secondary Master Hard Disk Error
The ATAPI device configured as Secondary Master could not be correctly initialized by the BIOS.
This message is typically displayed when the BIOS is trying to detect and configure ATAPI devices
in POST.
Secondary Slave Hard Disk Error
The ATAPI device configured as Secondary Slave could not be correctly initialized by the BIOS.
This message is typically displayed when the BIOS is trying to detect and configure ATAPI devices
in POST.
Primary Master Drive - ATAPI Incompatible
The IATAPI device configured as Primary Master failed an ATAPI compatibility test. This message
is typically displayed when the BIOS is trying to detect and configure ATAPI devices in POST.
Primary Slave Drive - ATAPI Incompatible
The ATAPI device configured as Primary Slave failed an ATAPI compatibility test. This message
is typically displayed when the BIOS is trying to detect and configure ATAPI devices in POST.
Secondary Master Drive - ATAPI Incompatible
The ATAPI device configured as Secondary Master failed an ATAPI compatibility test. This message
is typically displayed when the BIOS is trying to detect and configure ATAPI devices in POST.
Secondary Slave Drive - ATAPI Incompatible
The ATAPI device configured as Secondary Slave failed an ATAPI compatibility test. This message
is typically displayed when the BIOS is trying to detect and configure ATAPI devices in POST.