Filter
Top Products
ADAC Ultra2 S466 Hardware Guide
90
68-Pin SCSI Connector Pinout, Continued
High-Density Single Ended Connector The following applies to the high-
density SCSI connector table on the previous page:
• A hyphen before a signal name indicates that signal is
active low.
• The connector pin refers to the conductor position
when using 0.025 inch centerline flat ribbon cable with
a high-density connector (AMPLIMITE.050 Series
connectors).
• Eight-bit devices connected to the P-Cable must leave
the following signals open: -DB (8), -DB (9), -DB
(10), -DB (11), -DB(12), -DB (13), -DB (14), -DB
15), and -DB (P1).
•
All other signals should be connected as defined.
Caution
Lines labeled RESERVED should be connected to Ground
in the bus terminator assemblies or in the end devices on the
SCSI cable.
RESERVED lines should be open in the other SCSI
devices, but can be connected to Ground.