Filter
Top Products
ADAC Ultra2 S466 Hardware Guide
54
Installation Steps
ADAC Ultra2 S466 provides extensive customization
options. If you need only basic ADAC Ultra2 S466
features and your computer does not use other adapter
cards with resource settings that may conflict with ADAC
Ultra2 S466 settings, even custom installation can be quick
and easy.
Step Action Additional Information
1 Unpack the ADAC Ultra2 S466 controller
and inspect for damage. Make sure all
items are in the package.
If damaged, call your
Gateway OEM support
representative.
2 Turn the computer off and remove the
cover.
3 Make sure the motherboard jumper settings
are correct.
4 Install cache memory on the ADAC Ultra2
S466 card.
4 MB minimum cache
memory is required.
5 Check the jumper settings on the ADAC
Ultra2 S466 controller.
See page 57 for the ADAC
Ultra2 S466 jumper
settings.
6 Set SCSI termination.
7 Install the ADAC Ultra2 S466 card.
8 Connect the SCSI cables to SCSI devices.
9 Set the target IDs for the SCSI devices.
10 Replace the computer cover and turn the
power on.
Be sure the SCSI devices
are powered up before or at
the same time as the host
computer.
11 Run ADAC BIOS Setup. Optional.
12 Install software drivers for the desired
operating systems.
Each step is described in detail below.
Cont’d