Filter
Top Products
Chapter 7 Troubleshooting
81
Topic Information
Windows NT
Installation
When Windows NT is installed via a bootable CD, the
devices on the ADAC Ultra2 S466 will not be recognized
until after the initial reboot. The Microsoft documented
workaround is in SETUP.TXT:
SETUP.TXT is on diskette 2 or the CD
To install drivers when Setup recognizes one of the
supported SCSI host adapters without making the devices
attached to it available for use:
1 Restart Windows NT Setup.
2 When Windows NT Setup displays
Setup is inspecting your computer’s hardware
configuration...,
press <F6> to prevents Windows NT Setup from
performing disk controller detection. This allows
you to install the driver from the Drivers disk you
created. All SCSI adapters must be installed
manually.
3. When Windows NT Setup displays
Setup could not determine the type of one or more
mass storage devices installed in your system, or
you have chosen to manually specify an adapter,
press S to display a list of supported SCSI host
adapters.
4 Select Other from the bottom of the list.
5 Insert the Drivers Disk you made when prompted
to do so and select ADAC Ultra2 S466 from this
list. In some cases, Windows NT Setup repeatedly
prompts to swap disks. Windows NT will now
recognize any devices attached to this adapter.
Repeat this step for each host adapter not already
recognized by Windows NT Setup.