Filter
Top Products
GBC 3064WF Operation Manual
© 2005 General Binding Corporation Page 16
THERMAL
LAMINATE
THERMAL
LAMINATE
THERMAL
LAMINATE
Webbing Thermal Film Using Threading Card
CAUTION: The laminator rollers will be hot and
can burn you.
1. Turn the Main Power ON /OFF to On.
2. Set top and bottom temperatures to the appropriate
setting for the film type used.
3. Ensure no brake tension is applied to the film shafts.
4. Pull the top roll film down under the upper idler bar
and allow to drape over the top heat roller (Fig. 19)
5. Pull the lower film behind the lower idler bar, Lower
the table, Pull Film up towards the film draped over
the top heat roller and adhere the lower film to the
upper Film (Fig. 20).
6. Pivot the table back to its feeding position while
ensuring the threading card is on top of the feed table
(Fig. 21).
7. Use a threading card to push the two materials into
the heat roller nip.
8. Lower the main roller to initial contact with the
threading card.
9. Ensure FRONT is selected for Motor direction and
Press the Foot Switch
10. From the rear of the machine, guide the web over the
chill idler, if installed, and through the pull rollers.
11. Once the web has entered the pull roller nip, lower
the pull roller. Adjust unwind film tension; use as
little tension as possible to get smooth output.
(See Page. 9)
12. Once the threading card has completely exited the
pull rollers, press the “STOP” ( ) button.
13. Now refer to the section titled “START
LAMINATING”.
Figure 19
Figure 20
Figure 21