Filter
Top Products
GBC 3064WF Operation Manual
© 2005 General Binding Corporation Page 25
- A - - B -
- A - - B -
- A - - B -
Figure 39
Figure 40
Figure 41
Heat
The “READY” indicator may extinguish if the speed
is set too fast for the material being laminated. Either
lower the speed setting or press “STOP” ( ) and
wait until the “READY” indicator illuminates.
Operation of the laminator for more than thirty
minutes at a time may necessitate a lower speed
setting. It is recommended that, during periods of
long runs, the items being laminated are alternated
between thick and thin. Do not combine thick and
thin items at the same time, as this will result in a
poor edge seal around the thinner material. If you are
unsure that the laminator is set at the proper speed
for the item to be laminated, run a test piece (scrap)
of the same or similar material through the
Laminator. This procedure is recommended because
rotating the heat roller prior to lamination will more
evenly distribute the heat.
Make speed adjustments if necessary.
Output
1. “D” waves in the image (Fig. 39 A).
• Check paper tension.
• Paper may be damp or not dry.
2. “D” waves in the laminate (Fig. 39 B).
• Check main roller pressure.
• Check pull roller pressure.
3. Straight waves in output (Fig. 40 A).
• Check operational settings for materials
being used.
• Check clutch tension.
4. Indent waves in output after pull rollers
• Insufficient cooling time.
• Output was handled prior to cooling.
• Use cooling feature if not on.
• Machine was stopped on print.
5. Angled waves in the output
• Main air Supply setting
• Check main Roller Pressure.
• Check main roller pressure.
• Check pull roller pressure.
• Check for Paper Tension.