Filter
Top Products
GBC 3064WF Operation Manual
© 2005 General Binding Corporation Page 21
APPLICATIONS
TRAILOR BOARD
LEADER BOARD
BOARDS
MOUNT
ADHESIVE
PRE-COATED BOARD
IMAGE
RELEASE LINER
ROLL TO ROLL OPTION
IMAGE
RELEASE LINER FROM PSA FILM
OUTPUT
KRAFT
PAPER
OPTI ON
MOUNT
ADHESI VE
Tips for Pre Coating Boards
1. Load the laminator as illustrated in (Fig. 30).
Remove chill idler.
2. The width of the roll should not exceed the
width of the board by more than 1/2 in. (1.3
cm).
3. Use a leader board to set the main roller and
pull roller pressure prior to webbing.
4. Use a leader board to start the run and a trailer
board to finish the run.
5. Using the pull rollers will allow you to leave
gaps between boards.
6. If not using the pull rollers, have the boards
nearby to butt end to end during feeding.
Tips for Mounting Pre Coated Boards
1. Use a leader board to set the main roller
pressure prior to mounting the image.
2. Ensure the chill idler is removed and the rear
slitter is to one side.
3. Do not stop once you have started the mounting
process through the machine. (Fig. 31)
Note: This application can also be performed from
the rear operating position. Reference Fig. 34 for
Illustration.
Tips for Single Sided lamination
1. Load the laminator as illustrated in Fig. 32.
2. Use kraft paper for one-sided lamination When
ever the items to be laminated are narrower than
the film you are using.
3. If not using kraft paper, use a scrap piece to
finish the run or you will have adhesive on your
rollers.
4. For high volume runs, use Kraft paper and the
lower rear rewind for roll to roll operation.
5. Running the web over the chill idler may
improve the Flatness of the output.
6. A little heat 125
o
F (52
o
C) may help eliminate
silvering effects associated with PSA films.
Figure 30
Figure 31
Figure 32