Filter
Top Products
GBC 3064WF Operation Manual
© 2005 General Binding Corporation Page 22
MOUN T
ADHES I VE
ROLL TO ROLL OPTION
I MAGE
RELEASE LINER FROM PSA FILM
OUTPUT
THERMAL
OR PSA
FILM
IMAGE
BOARD
RELEASE LINER
THERMAL
FILM
ROLL TO ROLL OPTION
IMAGE
OUTPUT
THERMAL
FILM
Figure 33
Figure 34
Figure 35
Tips for Creating a Decal
1. Load the laminator as illustrated in Fig. 33.
2. The over laminate may be PSA or thermal type.
3. If using thermal type, pay attention to the Poly-
in/Poly-out rule.
4. Run a test material prior to running the actual
image to ensure flat output.
5. Use minimal brake tension to achieve quality
output.
6. Do not web the PSA mount adhesive around the
lower web idler.
Tips for mounting a Decal
1. Use a leader board to set the pull roller pressure
Prior to mounting the image.
2. The image should not exceed the width of the
board by more than 1 in. (2.54 cm) per side.
3. Tack about 1 in. (2.54 cm) of the leading edge
of the image to the leading edge of the board.
4. When tacking the leading edge, start in the
center and work to the sides.
5. Use a board that exceeds the size of the decal if
inexperienced in the mounting application.
Note: This application can also be performed from
the front operating position. Reference Fig. 31 for
Illustration.
Tips For Thermal Encapsulation
1. Load the laminator as illustrated in Fig. 35
Poly-in film is used for illustration purpose.
2. Refer to section titled “FILM LOADING &
THREADING” for Poly-out film.
3. Always use two rolls of film the same width.
4. Use minimal brake tension to achieve flat
output.
5. Increase speed gradually to maintain the
activating temperature required for the laminate
you are using.
6. Length and width of image, ink coverage and
paper type may affect the temperature and speed
recommended in the SPEED/ TEMPERATURE
GUIDE.