Filter
Top Products
GBC 3064WF Operation Manual
© 2005 General Binding Corporation Page 7
CONTROL GUIDE
A. Power ON/OFF (I/O):
Located at the back left of the machine applies power to the
laminator. The control panel display will illuminate when
position marked “I” is pushed. The Off position, marked “O”
removes power from the laminator.
B. Control Panel (Figure 5)
1. Main Roll Nip Pressure relevant pressure in percentage:
2. Top Roll Display
• Displays Temperature in “
o
C “or “
o
F” of the Top Heater
(Both Set Temperature and Current Temperature)
• LED Marked “
o
C” if Illuminated indicates reading in “
o
C “
• LED Marked “
o
F” if Illuminated indicates Temperature reading
in “
o
F”
• LED Marked “Ready” illuminates when set temperature is
reached.
{a}. Control Switches:
⌃
- When Pressed Increases the Temperature
- When Pressed Decreases the Temperature
MEAS- Press and Hold to Display Current Top Roller
Temperature
3. Main Switch (TOP Heater): When pressed to the
Position turns On the top heater, when pressed to the
Position turns Off the top heater.
4. Bottom Roll Display
• Displays Temperature in “
o
C” or “
o
F” of the Bottom Heater
(Both set Temperature and Current Temperature when
MEAS switch is pressed)
• LED Marked “
o
C” if Illuminated indicates reading in “
o
C”
• LED Marked “°F” if Illuminated indicates Temperature reading
in “
o
F”
• LED Marked “Ready” illuminates when set temperature is
reached.
MEAS- Press and Hold to Display Current Bottom Roller
Temperature
{b}. Control Switches
∧ - When Pressed Increases the Temperature
∨ - When Pressed Decreases the Temperature
MEAS-Press and Hold to Display Current Bottom Roller
Temperature
5. Main Switch (Bottom Heater): When pressed to the
position turns On the bottom heater, when pressed to the
position turns Off the bottom heater.
6. Fan Switch: Switches cooling fan ON / OFF
7. Laminator Main Control Switch: Switches the
laminator between “RUN” and “STOP” modes.
8. Machine Power On Light: Green light illuminated –
Machine On.
9. Laminator Direction Motion Control Switch: Controls the
forward and rearward movement of the laminator.
10. Laminator Speed Control:
Regulates the speed of laminator feed.
• Outer Scale in Feet/Minute.
1
2
3
a
4
b
5
6
1
7
9
8
Figure 5