Filter
Top Products
GBC 620os Operation Manual
© 2007 General Binding Corporation Page 8
FRONT CONTROL GUIDE
Figure 2
LCD Display:
• HEAT: This displays the Temperature the
machine is set at. Figure 2. indicates the set
e
e location
run
the
nt will indicate how
many sheets of media were run through the
laminator. To reset the counter to “0”, press
RESET shown in Figure 1.
temperature is 32*F. To read the actual
temperature of the Heat Roller, press and hold
the MASTER DIAL. (See Figure 1.)
•
WAIT: After setting the desired temperature, the
LCD will display “WAIT” until the temperatur
reaches the set point. After the machine reaches
the set point, the LCD will read “READY” and
the operator can start running the machine.
•
BURST: The Burst value tells the laminator
when and where to activate the Burst Roller. A
decal located on the side frame between the pull
rollers and the Bursting Roller reflects values
from a range of 580-660. To change th
of the burst, press the BURST then turn the
MASTER DIAL to dial in the desired value in
relation to the decal on the side frame
.
•
SPD: The Abbreviation “SPD” refers to the set
speed of the machine. The range of speed is 1-
15. At speed 01, the machine will
approximately 3ft/mn. Each increment is equal
to about 3ft/mn. SPD 15 is 45ft/mn. To adjust
this value, use MOTOR SPEED. Figure 1.
•
LENGTH: The value displayed next to length
refers to the sheet size of the media being used.
In Figure 2. the medias sheet length is 18 inches.
To adjust the length, press LENGTH and use
MASTER DIAL to increase or decrease your
sheet size. The sheet size ranges from 8 inches-
30inches and increases by 1/32
nd
increments.
•
SHEET COUNT: Sheet cou
Figure 3
•
HEAT: (Figure 3.) After setting the Heat Roller
temperature, the laminator is protected with heat
sensor protection. In the event that the IR
Sensor fails, or a foreign object such as a misfeed
image blocks the IR Sensor, the IR Sensor will
detect a sudden/drastic change in temperature and
an alarm will sound and “H-Err” will appear on
the LCD. Stop the laminator by pressing STOP,
locate the IR Sensor, (Refer to Know Your
Laminator Section) and clear the image from the
path of the IR Sensor. Rest the alarm by pressing
the MASTER DIAL. (Figure 1.) At this time,
simply press RUN and continue the job.