Filter
Top Products
Page 5 - 20
Operations
© GBC Films Group June 2000
Orca 80-99 Operation and Maintenance Manual
PROCESS CONTROL CHART 2-6
Process: Hot overlaminate with Pressure Sensitive Mount Adhesive (Second Pass)
Materials (top/bottom): / 3/16" Foamcore
Front Control Panel
Adjustments
Rear Control Panel
Adjustments
Top Brake OFF / NA Top Heat OFF / NA
Top Clutch OFF / NA Bottom Heat OFF / NA
Laminator Roller OFF / NA Top Cooling Fans OFF
Bottom Brake (front) OFF / NA Bottom Cooling Fans OFF
Bottom Clutch (front) OFF / NA Pull Roller Clutch ON / 40 p.s.i.
Forward/Reverse REVERSE Pull Roller Pressure ON / 30 p.s.i.
Speed 2 - 3 f.p.m. Bottom Brake (rear) OFF / NA
Laminator Roller Shims N/A Bottom Clutch (rear) OFF / NA
Pull Roller Shims 3/16"
Helpful Hints/Notes:
When mounting keep an even wrap around the upper pull roll to eliminate any wrinkles due to
uneven feed of the image. During the mounting process, it is also helpful to have a table the
same height as the pull roller nip to help feed the board and image into the pull rollers.