Filter
Top Products
Page 5 - 26
Operations
© GBC Films Group June 2000
Orca 80-99 Operation and Maintenance Manual
PROCESS CONTROL CHART 2-9
Process: Cold Overlam only (using a sled)
Materials (top/bottom): Pro-Gloss / 3/16" board (to be used for the sled)
Front Control Panel
Adjustments
Rear Control Panel
Adjustments
Top Brake ON / 40 p.s.i. Top Heat ON / 115
o
F (46
o
C)
Top Clutch ON / 20 p.s.i. Bottom Heat OFF / NA
Laminator Roller ON / 40 p.s.i. Top Cooling Fans OFF
Bottom Brake (front) OFF / NA Bottom Cooling Fans OFF
Bottom Clutch (front) OFF / NA Pull Roller Clutch OFF / NA
Forward/Reverse FORWARD Pull Roller Pressure OFF / NA
Speed 4 - 6 f.p.m. Bottom Brake (rear) OFF / NA
Laminator Roller Shims 3/16" Bottom Clutch (rear) OFF / NA
Pull Roller Shims NA
Helpful Hints/Notes:
Use a starter board of the same thickness as the sled being used to start the laminate into the nip.
Lay the image on the sled and follow the leader board into the nip while maintaining paper
tension on the image being overlaminated.