Filter
Top Products
1-8 VersaMax Serial to Ethernet Adapter User's Manual – July 2000 GFK-1852
1
J. Reconnect by typing
telnet 191.12.3.77 9999
at the MS-DOS prompt, and then
pressing the Enter key. This will take you to the VMSE Configuration screen,
shown in Figure 1-7.
K. Use this screen to configure the VMSE. An example is provided in the
following “Configuration” section.
Note
The VMSE comes equipped with SNP/SRTP firmware by default.
If you are using a protocol other than SNP/SRTP, you must load
the correct firmware for your protocol from the supplied CD (see
Chapter 5 for firmware upgrade details) before proceeding with
configuration. Note that changing the firmware will not change
the IP address set in the previous steps.