Filter
Top Products
GFK-1852 Chapter 5 Monitor Mode and Firmware Upgrade 5-5
Monitor Mode and Firmware Upgrade
5
Windows NT Command Line Example Code Explanation
C:\>tftp –
i
3.16.27.40 PUT d:\snp42d.rom G1
1
3
4
5
6
7
2
1.
C:\> is the command prompt
2.
tftp is the execute command for the TFTP software
3.
-i tells TFTP to send a binary file
4.
The host field is the IP address of the target VMSE
5.
PUT is the command that sends the file to the VMSE
6.
The source file (including full path) to be sent to the VMSE
7.
The destination field is like a password in the target VMSE
VMSE Firmware File List:
Functionality
File for Serial
Download
File for Network
Download
Destination
(password)
SNP/SRTP SNP42.HEX SNP42.ROM G1
PassThru CoBox3-6.Hex CoBox3-6.ROM 3Q
Modbus Modbus.Hex Modbus.Rom 4D
Destination (Password)
Destination (password ) for Network loads depend on what file is already in the
VMSE. Enter the Destination code based on what is already in the VMSE not on
what you are downloading.
For example, if you are downloading PassThru into a new unit which has the default
software of SNP/SRTP, you would enter a destination of G1.
Note: The
destination is case sensitive. The letter “G” in this example must be upper case.