Filter
Top Products
GFK-1852 Chapter 1 Introduction and Quick Start 1-9
Introduction and Quick Start
1
Configuration
This section is just an overview. See Chapter 4 for configuration details.
Before proceeding with the configuration procedure, ensure that you have the correct
firmware loaded in the VMSE. The VMSE comes equipped with SNP/SRTP by
default. If you are using a different protocol, you must load the correct firmware for
that protocol. See Chapter 5 for instructions.
You have six Command choices at the Configuration screen Command Prompt (see
next figure). You do not have to press the Enter key after typing a command number
or letter.
•
1 – to configure Network/IP Settings
•
2 – to configure CH1 Serial and Protocol Settings
•
3 – to configure SNP ID to IP Mapping Table
•
d – to revert to default settings
•
s – to save your changes and quit
•
q – to quit without saving your changes
Figure 1-9. VMSE Configuration Screen
Command Prompt