Filter
Top Products
5-2 VersaMax Serial to Ethernet Adapter User's Manual – July 2000 GFK-1852
5
Command Description
GC
x.x.x.x Get configuration as HEX records
SC
x.x.x.x Set configuration from HEX records
PI
x.x.x.x Check with Ping if x.x.x.x is alive and reachable
AT
Show the VMSE’s ARP table entries
TT
Shows all the incoming and outgoing TCP connections (used
only with “monitor mode” from Telnet)
NC
Shows the IP configuration of the VMSE
RS
Resets the power on the VMSE
SI
x.x.x.x:n.n.n.n With this command, you can remotely assign an IP address to
another VMSE, where x.x.x.x is the new IP address and
n.n.n.n is the remote VMSE serial number written twice. For
example:
SI194.39.78.234:146.138.146.138
IP address = 194.39.78.234
Remote VMSE serial # (146-138) = 146.138.146.138
NOTE:
Since this is obtained by sending broadcast packets,
this IP assignment cannot be done over the routers.
QU
Quit - exit diagnostics mode
Command result codes:
0
OK, no error
1
No answer from remote device
2
Cannot reach remote device or does not answer
8
Wrong parameter(s)
9
Invalid command
Firmware Download Using Serial Port
Downloading is done in monitor mode. Once the VMSE is in monitor mode, by
using “DL” command, the VMSE will wait for the firmware image in Intel Hex
format. This must only be sent through the serial interface. When the end record is