Filter
Top Products
page | 21
3. Click the Unicast button under the Network Mode group. When selected,
the Unicast button will be highlighted in blue.
4. Click the Save button in the lower-right corner of the Network Mode group.
5. The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
6. Click the Reboot button near the bottom portion of the page to apply the changes.
7. Repeat steps 1 - 6 in order to congure the Sender unit to unicast mode.
Operating the DVI KVM over IP
Unicast and Multicast Modes
IMPORTANT: When switching between unicast and multicast
modes, both Sender and Receiver units need to be congured
identically.