Filter
Top Products
page | 26
3. Click the Multicast button under the Network Mode group. When selected,
the Multicast button will be highlighted in blue.
4. Click the Save button in the lower-right corner of the Network Mode group.
The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
If a display is connected to the Receiver unit, then the message “Starting USB”
will be displayed. For more information on using USB under multicast mode,
refer to USB under Multicast Mode.
5. Click the Reboot button near the bottom portion of the page to apply the changes.
6. Repeat the steps above in order to congure the Sender unit to multicast mode.
Operating the DVI KVM over IP
Unicast and Multicast Modes
IMPORTANT: When changing units between unicast and multicast
modes, both the Sender and Receiver units need to be congured
identically.