Filter
Top Products
4-29
Using Set-Up Mode
Adjusting Top-of-Form Origin
Print positions often change gradually when you use the printer over long periods of time.
The ADJUST function allows you to adjust these positions by fine-tuning the Top-of-Form
origin.
The following table describes the ADJUST options and values. Options are listed in the
order they are printed.
ADJUST Options and Values
• Overprinted values are the factory settings.
ADJUST
Options Values Description
<FNFOLD ADJ> Adjust the Top-of-Form origin for
continuous forms in increments of 1/60
inch (0.42 mm) from the physical top of
the page.
###/60 IN -10 to 10 (0)
Number of 1/60 inches
<MNUAL ADJ> Adjust the Top-of-Form origin for
single sheets in increments of 1/60 inch
(0.42 mm) from the physical top of the
page.
###/60 IN -10 to 10 (0)
Number of 1/60 inches
<RESVD 1> Reserved
<RESVD 2> Reserved
(Manual
Adjustment)
(Fanfold
Adjustment)