Filter
Top Products
11
Grasp the Slide Feeder rmly with one hand while holding the batch-
scan door open on the scanner with your other hand. Align the pins
and connector on the back of the Feeder with the holes and connector
inside the scanner. Gently press the Feeder down and in place,
making sure that the Feeder sits rmly and has a good connection
with the connector.
Turn on the scanner by pressing its on/o switch.
FlexColor detects that the scanner has been turned back on. e
Mount feeder window updates with new instructions.
Click on Continue in the Mount feeder window.
e scanner repositions its drum and then the Mount feeder window
updates again, asking you to mount the holder.
Open the magazine drawer by grasping it at the top and pulling it
down. It rotates forward on its hinge (B) and then stops, exposing the
magazine (C) with magazine drawer top (D) facing out (see Figure 5,
below). Note also the original-holder supports (A); this is where you
will insert the slide holder later in this procedure.
10.
11.
12.
13.
14.