Hasselblad 949 Scanner User Manual


 
8
Mounting and Unmounting
the Slide Feeder
e procedures for both mounting and unmounting the Feeder to/
from your scanner require that you use the soware-guided procedure
described below, which ensures that the mechanical pars of the scanner
and Feeder are correctly aligned for each step. Always use this soware
feature when you need to mount or unmount the Feeder. Otherwise, you
may damage your Feeder and/or scanner. Also, the unmount procedure
makes sure that the Feeder is correctly positioned for storage in its
original box.
Important notice! Never mount or unmount the feeder with power switched
on. It can cause damage to both scanner and feeder!
Mounting the Slide Feeder
Always use the procedure below to mount the feeder:
If you have not already done so, set up your Flextight 949 Scanner,
connect it to your computer and install the FlexColor soware as
described in your scanner and soware user manuals. Conrm that
the scanner is working correctly by making a test scan using one of
the standard original holders.
If there is still an original holder mounted inside the scanner, then
remove it. Close the light table, if it is open, by liing its front edge.
See your scanner manual for instructions.
Position the Flextight 949 Scanner so that its front edge is aligned
with the edge of your table. e Slide Feeder will hang over the edge
of the table when it is mounted.
Make sure the scanner is turned on and launch the FlexColor
soware. If FlexColor is already running, then quit and restart the
program.
1.
2.
3.
4.