HP (Hewlett-Packard) 16500B All in One Printer User Manual


 
Test the Expansion Interface Card
1
Ground the oscilloscope probe to the metal portion of the frame near the rear panel
of the expansion frame and check for TTL activity on the following pins.
U7 pins 11 through 18
U8 pins 2 through 9
U9 pins 5 through 9
If there is TTL activity on all of the pins indicated, then the signal paths from the
mainframe CPU board and the end of the expansion frame interface card are
considered working. Go to the next step.
If one or more of the signal lines do not show activity, then go to "Test the
Mainframe CPU Board" on the next page.
2 With the oscilloscope probe still grounded to the expansion frame, probe the
following pins.
U7 pins 2 through 9
U8 pins 11 through 18
U9 pins 11 through 15
If all of the signal lines show TTL activity, then go to the next step.
If one or more of the signal lines do not show TTL activity, then replace the
expansion frame interface board.
Bottom Side of Expansion Interface Card
Troubleshooting
To test the expansion frame interface
5–30