Filter
Top Products
Installing an Interface Expansion Board
Installing an
The printer’s standard interfaces are parallel (Centronics
x
2) and
Interface
serial (RS-232C
x
1). The currently available optional interfaces are
Expansion Board
LocalTalk and Ethernet. If the location of your printer is distant
from the computer, you can use the LocalTalk port or Ethernet port
of the computer to connect your printer. Fujitsu offers the optional
LocalTalk board and Ethernet board C for these purposes.
Notice:
When sharing the printer among multiple computers, setting the I/O
time-out short may cause a printing problem.
LocalTalk interface board
Ethernet interface board
Installing an Interface Board
Remove
the cover
1. To install an interface
board, first make sure the
I
or-inter is turned off.
Remove the interface board
slot cover from the back
right of the printer.
2.
Hold the board with the
parts mounting side left.
Slide the board into the
empty interface slot using
the guides, and push it until
it stops. Secure the board by
the two screws supplied
with it.
User’s Manual
3-5