Filter
Top Products
12.
If it is necessary to replace the wireless antenna cables and transceivers:
a. Release the wireless antenna cables from the clips and routing channel built into the display
enclosure.
b. Release the two pieces of tape that secure the wireless antenna cables to the display
enclosure.
c. Release the tabs built into the display enclosure that secure the wireless antenna cables.
d. Remove the two Phillips PM2.0×4.0 screws that secure the wireless antenna transceivers to
the display enclosure.
e. Remove the wireless antenna cables and transceivers. The wireless antenna cables and
transceivers are available in the Wireless Antenna Kit, spare part number 603780-001.
Reverse this procedure to reassemble and install the display assembly.
76 Chapter 4 Removal and replacement procedures ENWW