Filter
Top Products
122 Chapter 4 - Problem solving
EN
50.x
FUSER ERROR
A fusing error has occurred. Turn the printer off and then on.
50.4
PRINTER ERROR
alternates with
CYCLE POWER TO
CONTINUE
There is a problem with the power supply.
Remove the printer from any UPS supplies, additional power
supplies, or power strips. Plug the printer into a wall outlet and see if
this resolves the problem.
If the printer is already plugged into a wall outlet, try another power
source in the building that is independent of the one currently being
used.
The line voltage and current source at the printer location might need
to be inspected to ensure that it meets the printer’s electrical
specifications (see “Electrical specifications” on page 201).
51.x or 52.x
PRINTER ERROR
alternates with
CYCLE POWER TO
CONTINUE
A temporary printing error occurred.
Turn the printer off, then turn the printer on.
53.xy.zz
PRINTER ERROR
There is a problem with the printer’s memory. The DIMM that caused
the error will not be used. Values of
x
,
y
, and
zz
are as follows:
x = DIMM type
0 = ROM
1 = RAM
y = Device location
0 = Internal memory (ROM or RAM)
1 to 3 = DIMM slots 1, 2, or 3
zz = Error number
You might need to replace the specified DIMM.
Turn the printer off, and then replace the DIMM that caused the error.
54.1 REMOVE
SEALING TAPE
alternates with
FROM TONER
CARTRIDGE
The toner cartridge has been installed without removing the sealing
tape.
Open the top cover and remove the toner cartridge. Pull the sealing
tape tab to remove the strip. Reinstall the toner cartridge and close
the top cover.
Printer messages (continued)
Message Explanation or recommended action