Filter
Top Products
49
Replacing your tape drive
If your tape drive proves to be faulty and cannot be repaired and it is still covered by the
original warranty, it will be replaced.
To disconnect your drive
1 Unpack your replacement drive, and retain the packaging.
2 Switch off your server to power off the tape drive and any other devices that are on the same
SCSI bus.
3 Remove the cover from the server, see page 23.
4 Observing normal anti-static precautions (see page 23) remove any screws that are holding the
tape drive in place.
5 Disconnect the drive from the server’s power and SCSI cables and slide it carefully out of the
mounting bay.
6 Put the drive into the packaging that contained the replacement drive.
7 Return the faulty drive to your local HP Service Center. Instructions on where to return faulty
drives will be shipped with the replacement drive.
Note If you are not replacing the drive immediately, you should insert a blanking plate into the
empty bay. Replace the cover on the server and secure with screws, as appropriate.
To reconnect your tape drive
Follow the step-by-step instructions in this Getting Started guide.
ult960_master_internal.fm Page 49 Tuesday, September 21, 2004 4:13 PM