Filter
Top Products
Paper not present.
Load paper to print calibration
pattern
The paper axis calibration routine has been triggered without having
paper loaded.
Load paper; see Advance calibration
for details of the routine.
Paper too big to scan the
pattern after printing it
During paper loading for the Calibration routine, the printer has
detected that it will not be able to load the paper when it will be
needed for scanning. The minimum size required for the print is
65 cm (25 in) long and 50 cm (20 in) wide.
Load a smaller sheet that satisfies this minimum requirement.
Paper too big
Press ENTER to retry
Press CANCEL to abort
While loading paper into the printer (roll or sheet), the printer has
found that it is either too wide or too long (sheet only) to be loaded
properly.
Press the Enter key to load smaller paper, or the Cancel key to stop
the load.
Paper too small for a
diagnostic print
The Troubleshooting utility has found that the single sheet loaded in
the printer is too small for a Diagnostic Print.
Load a roll of paper, or a sheet that is A3 size or larger.
Paper too small
to align printheads
Load bigger size to
align
Press ENTER to continue
The paper loaded is not big enough to contain the alignment pattern.
Unload the paper (select Unload roll or Unload sheet from the
Paper menu) and then load paper that is large enough—at least A4/
Letter-size in landscape mode for Standard alignment, or A3/B size
in landscape mode for Special alignment.
Front-panel messages
Message Explanation and action