Filter
Top Products
Removal and replacement procedures 33
2.
Extend or remove the server from the rack ("Extend the server from the rack" on page 26).
3. Remove the access panel ("Access panel" on page 30).
4. If any full-length expansion boards are installed, remove the full-length expansion board shipping
bracket ("Full-length expansion board shipping bracket" on page 31).
5. Remove the PCI riser cage.
To replace the component, reverse the removal procedure.
SAS hard drive blank
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
Remove the component as indicated.
To replace the blank, slide the blank into the bay until it locks into place.
Hot-plug SAS hard drive
To remove the component: