Filter
Top Products
8
Installing Accessories in the New Desktop Package
Installing a Hard Disk
Drive in the Top Rear
Shelf
Installing a Hard Disk
Drive in the Bottom Rear
Shelf
1. Unscrew the retain-
ing bracket at the rear
of the computer
2. Remove the rear tray by sliding it
forward about 1.5 cm (1/2 inch),
and lifting it up and out
3. Align the disk drive with the
holes in the tray, and secure using
the screws provided
4. Connect the data cable
and power cable to the
rear of the drive
1. Unclip the metal plate at the rear
of the computer, and remove it
2. Remove the tray by pushing it from
the inside, and sliding it out the back
of the computer
3. Secure the 3.5-inch drive
(shown above) or 5.25-inch drive
(shown below) on to the tray
with the screws provided
4. Slide the tray back into the rear of
the computer
5. Replace the metal plate. Insert the
flat end first then push it until it
clicks into place.
1book.bk : 1ch01.fb4 Page 8 Wednesday, April 30, 1997 3:36 PM