Filter
Top Products
5% 35
Revision page parameters
Parameter Descriptions
Box Version Product version
FW Ver. Version of firmware installed in the digital sender.
FW Date Release date of the firmware installed in the digital sender.
HPJetDirect Prd. # Product number of the network interface card:
●
HPJ3113A
Ethernet (10Base-T) networks
HPJetDirect FW Rev. Version of firmware installed on the network interface card (G.xx.xx).
MAC Address Unique LAN hardware address assigned to the network interface card at the
time of manufacture (for example, 0060B072525E).
IP Address Unique TCP/IP address of the network interface card. This is assigned by the
administrator
Subnet Mas If subnets are used, the filter used to identify the subnet of the HPJetDirect
print server (network interface card). This is assigned by the administrator.
TCP/IP statu Status of the connection to the network:
●
INITIALIZING
The network interface card is searching for a valid IP address. After 2 minutes, a default IP
address is automatically assigned.
●
READY
The network interface card has been assigned an IP address and is actively connected to the
network.
●
ERROR
A network or network interface card error has been detected.
Gateway Addr. IP address of the default gateway server used to communicate with nodes on
other subnets or networks.
Received pkts Total number of packets received without error.
Bad packets Total number of packets received with errors.
Framing err . Total number of packets received that contained a CRC (cyclic redundancy
check) or framing (alignment) error.
Transm. pkts Total number of packets transmitted without error on the network.
Collisio n Total number of packets that were not transmitted due to successive collisions.
Late collision Total number of packets that were not transmitted due to late collisions
(collisions after the 64th byte of a packet).