Filter
Top Products
Installing the A5150A Adapter
Looking at Adapter Installation
Chapter 2 25
OLR of A5150-60001 The online replacement operation preserves the
initiator ID and speed settings across the replacement. The auto
termination setting for this HBA is over-ridden by the jumper settings on
the board.
Before installation, ensure that the auto termination jumpers are set to
the same position as they were on the replaced HBA.
Besides the cautions noted above, the A5150-60001 can be Online
Replaced without special considerations. See the Configuring HP-UX
Peripherals manual for the steps that are necessary to OLR this HBA.
OLR of A5150-60101 the A5150-60101 can be Online Replaced with
one special consideration.
The HBA being replaced MUST have been running with auto termination
enabled.
If the above condition is met, you may OLR the HBA. See the
Configuring HP-UX Peripherals manual for the steps that are necessary
to OLR this HBA.
NOTE Until you complete the OLR, additional SCSI error messages might be
written to the /var/adm/syslog.log file. Do not be concerned about
these messages; they do not affect the result of the OLR process.
Install/Replace With System Powered Down
Check the manual supplied with the server to perform the following
installation:
Step 1. Shut down the operating system.
Step 2. Power off the system and unplug power cords for all components in the
server.
Step 3. Locate the PCI slots for your server. Remove any cabinet cover.