Filter
Top Products
Installing the A5150A Adapter
SCSI Bus Termination
Chapter 234
Step 1. Check the PDC version, by booting the system to the BCH prompt and
then doing the following:
a. At the Main Menu, type in (for Information Menu).
b. At the Information Menu, type fv (to display the firmware version).
The output could look like this:
FIRMWARE INFORMATION
Firmware Version: 39.41
Table 2-3, earlier in this document, shows the required PDC versions for
using auto termination on each HP 9000 system. If you do not have a
correct PDC version on your system, contact your HP support
representative.
Step 2. Determine the HBA’s path by doing the following:
a. If already at the Main Menu, type in (for Information Menu); go to
step b.
If not already at the Main Menu, type main (to return to the Main
Menu), type in (for Information Menu), then go to step b.
b. At the Information Menu, type io (to display I/O interface
information). The output could look like this:
PCI DEVICE INFORMATION
Path Vendor Device Bus Slot
Description (dec) ID ID # #
---------------- ------- ------ ------- ----- ----
.
.
SCSI bus cntrl 0/2/0/0 0x1000 0xb 16 6
In this example, the HBA’s path is 0/2/0/0 (shown in bold, for emphasis,
in the listing above).
Step 3. Change the HBA’s auto termination state by doing the following:
a. If already at the Main Menu, type ser (for Service Menu); go to stepb.
If not already at the Main Menu, type main (to return to the Main
Menu), type ser (for Service Menu), then go to step b.