Filter
Top Products
S
OLVING
PROBLEMS
6.6
Solving Network Printing Problems
General Problems
Problem Solution
System does not function with some wrong
values entered by mistake while configuring.
Possibly the parameters in the network
card are corrupted. Restart the system
and set to factory defaults. See
"Network card Default Setting (When
you use the Network Card)" on page 1.7
Not able to access from SNMP Manager. Try pinging from the same system on
which SNMP manager is running. If it
does not succeed, there must be a
problem with network connectivity
between the manager and the network
card. If ping succeeds, verify that
community names with sufficient
permissions have been used.
You cannot see any of DHCP server, BOOTP
server or RARP server, when you want to set IP
address to print server.
You should set IP address, Subnet Mask
and Default Gateway to print server
using Set IP.
Print server does not print using TCP/IP
protocol.
1. Check whether TCP/IP protocol is
installed in your PC.
2. Check whether your PC is on the
same network with print server.
The name of printer is displayed empty while
adding a port and the printer doesn’t function.
Assign IP Address by using the Set IP.