Filter
Top Products
P
RINTING
F
ROM
DOS A
PPLICATIONS
A.6
Config Tab
You can configure various printer features.
•
Emulation
selects the emulation for printing a document. The
factory default is
Auto
.
•
Power Save
determines the length of time the printer waits
after a job is printed before it goes to a reduced power state. If
the printer is used frequently, select
OFF
which keeps the printer
ready to print with the minimum warm-up time. This uses more
power to keep the printer warm and ready to print.
•
Auto Continue
determines what action the printer should take if
the Multi-Purpose Tray is empty when a manual feed print job is
sent to the printer. If it is checked, the printer will pick up the
paper from the tray 1 after fifteen seconds. Otherwise, the
printer will wait for you to load paper in the Multi-Purpose Tray.
•
Jam Recovery
determines what action the printer should take
when a paper jam occurs. If it is unchecked, the printer does not
reprint a page that has jammed. If it is checked, the printer
keeps the image in memory for a printed page until the printer
signals that the page has successfully printed. The printer
reprints all jammed pages.
•
Toner save
determines the toner quantity the printer should use
when printing. If it is checked, the printer conserves toner when
printing. The default value is unchecked, which provides 100%
usage.
•
Auto Clean Drum
makes the printer print out a cleaning sheet
which clean the drum inside the toner cartridge automatically
every 500 print pages. This feature activates as a default
depending on the country.