![](http://pdfasset.owneriq.net/d/07/d079714b-e413-459d-9c8d-7f005d7c630f/d079714b-e413-459d-9c8d-7f005d7c630f-bg17c.png)
Removing the Holding Tray Belt
1 Remove all the screws securing the plate (see Figure A-20,
callout 1).
2 Remove (1) E-clip shown in Figure A-20, callout 2.
3 Remove the bushing underneath the E-clip.
4 Release (2) latch points shown in Figure A-20, callout 3.
Note:
The (2) washers on the gear beside the bushing
are now loose. Remove and set aside.
5 Release the wires from the wire holder, allowing the cover to
move aside to access the gears.
(continued on next page)
Figure A-20 Holding Tray Belt Cover Plate
A -24 Duplexer