Filter
Top Products
4. Click the Settings tab to access device settings.
5. Make any configuration changes, and then click Apply.
6. Close the Embedded Web Server.
Related topics
“
View and print network settings” on page 23
Use the Embedded Web Server to modify network settings
The Embedded Web Server gives you an intuitive interface to your network connection
parameters.
To use the Embedded Web Server to modify network settings
1. Print a network configuration page to find the IP address for the HP All-in-One.
2. In the Address box in your Web browser on your computer, type the IP address of
the HP All-in-One, as shown on the network settings page. For example, http://
192.168.1.101.
The Embedded Web Server Information page appears, showing information for the
HP All-in-One.
NOTE: If you are using a proxy server in your browser, you might need to disable
it to access the Embedded Web Server.
3. Click the Networking tab.
4. Click Wired (802.3) in the navigation menu.
5. Make your changes, and then click Apply.
Related topics
“
View and print network settings” on page 23
Network configuration page definitions
The network configuration page shows the network settings for the HP All-in-One. There
are settings for general information and 802.3 wired (Ethernet).
For information on how to print a network configuration page, see “
View and print network
settings” on page 23. For additional information on terms used here, see the “Network
glossary” on page 29.
This section contains the following topics:
•
General network settings
•
Wired (802.3) network settings
Chapter 4
26 Finish setting up the HP All-in-One
Finish setup