Filter
Top Products
Troubleshooting tools
Component diagnostics
LED diagnostics
Network LEDs (network models only)
The onboard network solution has two network port LEDs. When the product is connected to a properly
working network through a network cable, the yellow LED indicates network activity, and the green LED
indicates the link status. A blinking yellow LED indicates network traffic. If the green LED is off, a link
has failed.
For link failures, check all of the network cable connections. In addition, you can try to manually
configure the link settings on the onboard network solution by using the product control-panel menus.
1.
Touch the Setup
button.
2. Scroll to, and then touchNetwork Setup.
3. Scroll to, and then touch Link Speed.
4. Touch the appropriate link speed.
Control panel LEDs
The state of the Ready light and Attention light on the product signal the product status. The following
table outlines the possible control-panel light states.
Product state Ready light state Attention light state
Initializing Blinking Blinking
Ready On Off
Receiving data/processing job or
cancelling job
Blinking Off
Error message Off Blinking
Fatal error (49 or 79 error)
1
On On
1
The product will power off and then power on after one of these errors occurs.
Memory card LED (memory-card models only)
When a memory card is inserted into the correct memory-card slot, this LED turns on. If the LED is not
lighting, try the following actions:
●
Make sure that the memory card is in the correct slot.
●
Make sure that the memory card is not defective.
116 Chapter 2 Solve problems ENWW