Filter
Top Products
Power connector cable
Description Spare part number
Power connector cable 603692-001
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 43), and then remove the following components:
a.
Accessory cover (see
Hard drive on page 44)
b.
Keyboard (see
Keyboard on page 53)
c.
Top cover (see
Top cover on page 56)
d.
Display assembly (see
Display assembly on page 65)
Remove the power connector cable:
1. Disconnect the power cable (1) from the system board.
2. Release the power cable from the clips (2) built into the base enclosure.
3. Remove the Phillips PM2.5×4.0 screw (3) that secures the power connector to the base enclosure.
4. Remove the power connector bracket (4) The power connector bracket is included with the base
enclosure spare part kit, spare part number 603689-001.
74 Chapter 4 Removal and replacement procedures