Filter
Top Products
Power connector cable
Description Spare part number
Power connector cable (includes bracket) 736358-001
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the display panel (see
Display assembly on page 74).
5. Remove the service cover (see
Service cover on page 37).
6. Remove the battery (see
Battery on page 39).
7. Remove the RJ-45 module cover (see
RJ-45 module cover on page 49).
8. Remove the USB/audio board (see
USB/audio board on page 52).
Remove the power connector cable:
1. Remove the 2 Phillips PM2.5×5.5 screws that secure the left display hinge to the computer, and
then rotate the hinge upward (2).
2. Disconnect the power connector cable from the system board (1), and then remove the cable from
the clip build into the fan (2).
3. Remove the 2 Phillips PM2.5×3.5 broadhead screws that secure the bracket that sits atop the
power connector (3).
Component replacement procedures
53