Filter
Top Products
Installing a 3.5-inch device
1. Prepare the computer for disassembly (Preparation for disassembly on page 85).
2. Remove the access panel (Access panel on page 86).
3. Remove the front bezel (Front bezel on page 87). If you are installing a drive in a bay covered by
a bezel blank, remove the bezel blank. See
Bezel blanks on page 90 for more information.
4. Install 6-32 guide screws in the holes on each side of the drive.
NOTE: HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to Drives
on page 99 for an illustration of the extra guide screws location.
When replacing a drive, transfer the four 6-32 guide screws from the old drive to the new one.
5. Rotate the drive cage to its upright position.
Drives
103