Filter
Top Products
Hardware options installation 55
6.
Align the notch on the bottom edge of the memory module with the keyed surface of the DIMM slot, and
then fully press the memory module into the slot until the latches snap back into place.
7. Install the chassis cover (on page 19).
8. Connect the power cord to the server ("Connecting the power cord" on page 28).
9. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
10. After installing the DIMMs, to configure memory protection mode, use RBSU ("HP ROM-Based Setup
Utility" on page 71).
Expansion board options
The server has one low-profile PCIe2 x16 expansion slot for controller option installation.
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP Product Bulletin website (http://www.hp.com/go/productbulletin).
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all PCI slots have either an expansion slot cover or an expansion board installed.
To install the component:
1. Power down the server (on page 15).
2. Disconnect the power cord from the AC source.
3. Disconnect the power cord from the server.
4. Remove the chassis cover (on page 19).
5. To open the expansion slot cover retainer latch, press it.
6. Remove the expansion slot cover.