HP (Hewlett-Packard) E3S87UTABA Personal Computer User Manual


 
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
Memory modules
Processor
Expansion cards
To remove the system board:
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 49).
2. Remove the access panel (
Access Panel on page 50).
3. Remove the front bezel (
Front Bezel on page 51).
4. Remove any expansion cards (
Expansion Cards on page 56).
5. Disconnect all cables from the system board.
6. Remove the six screws that secure the system board to the chassis.
NOTE: HP Pro 3405/3505 model system boards are secured with eight screws.
7. Slide the system board toward the front of the chassis, and then lift it up and out of the chassis.
To install the system board, reverse the removal procedure.
NOTE: When replacing the system board, you must also change the chassis serial number in the
BIOS.
NOTE: After installing a new system board, always update the system ROM to ensure that the
latest version of the BIOS is being used on the computer. The latest system ROM BIOS can be found
at:
http:\\h18000.www1.hp.com/support/files.
84 Chapter 7 Removal and Replacement Procedures – Microtower Chassis