Filter
Top Products
Load and Print on Rigid Media 2-13
After briefly displaying the measured width of the media, the
control panel displays the media and margin measurements
(see Fig. 2-6):
• To change the margins, press the Margin Settings key.
Note The minimum Trailing Margin is 6 inches (15.2 cm),
to enable the pinch rollers to advance the media.
14. Press the ! (Proceed) key.
The control panel displays the message, “Media loaded suc-
cessfully,” and asks whether to save the Media Feed Num-
ber (MFN) for the current media type.
• To load the new MFN, press the
9 (Yes) key.
• To discard the new MFN and used the previously-saved
MFN, press the ( (No) key.
• To perform a media feed calibration or enter a different
MFN, press the Calibrate Media Feed key (For
instructions, see “Media Feed Calibration” on page 4-9.)
The Front Page screen appears.
15. Press the Go Online key.
Fig. 2-6. Rigid sheet measurements