Filter
Top Products
Removal and replacement procedures 31
LFF non-hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Back up all server data on the drive.
2. Power down the server (on page 23).
3. If the front bezel is not secured from inside the chassis, open the bezel.
4. If the front bezel is secured from inside the chassis, do the following:
a. Disconnect the power cord from the AC source.
b. Disconnect the power cord from the server.
c. Remove the chassis cover (on page 26).
d. Open the front bezel.