Filter
Top Products
2 Charging and Installing the Batteries 5
2
Charging and Installing
the Batteries
The HP CapShare appliance requires two charged batteries in order to operate. Two fully
charged batteries run the HP CapShare appliance for at least 50 copies.
Batteries should be paired when used for the first time, and the same two batteries should
be used in the HP CapShare appliance and charged together. If you interchange batteries
between pairs, you shorten the life and could ruin the batteries, which may result in poor
operation of the appliance.
To charge the batteries
1 Place the batteries in the battery charger. If you are charging only two batteries, they
must be placed in the same charging circuit. See the diagram inside the charger for
more information.
2 Plug the charger into a wall outlet. If the LED on the charger does not light, make
sure the batteries are properly installed in the charger and the outlet is active.
3 Allow four batteries to charge for approximately 14 hours. You can also quick-charge
two batteries for two hours.
Note
For optimal results, allow the batteries to charge to full capacity (10 to 14 hours).
4 When the batteries are fully charged, unplug the charger.
Note
Charge only fully discharged batteries. The HP CapShare appliance display indicates
when batteries are low and need to be recharged.
To install the batteries
1 Remove the battery compartment lid from the top of the HP CapShare appliance by
squeezing gently on the back of the lid and lifting it upward.
2 Insert the batteries into the appliance as indicated on the diagram inside the battery
compartment.
Joaquin.book Page 5 Wednesday, July 28, 1999 3:32 PM