Filter
Top Products
8-52 Removal and Installation
HP DesignJet 430, 450C and 455CA Printers
Removing the Entry Platen
Refer to figure 12 ' page 54
Removal
1. Remove the Overdrive Assembly ' page 8Ć50.
2. Remove the screw (item 1) that attaches the entry platen (item 2) to the
right sideĆplate.
3. Remove the screw (item 3) that attaches the entry platen (item 2) to the
left sideĆplate.
4. Release the indicated entryĆplaten clips by pushing the bottom front
corners of the entry platen up.
5. Pull the entry platen horizontally out from the Printer.