Filter
Top Products
Service Tests
4-29
HP DesignJet 430, 450C and 455CA Printers
Service Configuration Plot
The service configuration plot contains the following information:
DesignJet 4XX Service Configuration Plot
Firmware Release: X.XX.XX
SPROC release: X.X
(Servo-Processor Code revision number.)
EEROM Contents
NOTE: All EEPROM Parameters are since last EEROM Reset.
Number of Power Cycles: 19
Number of Color Plots: 13
Number of Black Plots: 15
Number of Pens: 7 6 6 6
Factory Spittoon: 0% used
Number of Bail Errors: 0
Number of System Errors: 2
Last System Error: 0x00000550 (errno = 0x3c0001)
Last System Error at file media_load.c line 2810
Bench Run:
Bench Run Maximum Y-Axis (Carriage-Axis) PWM: 127
Bench Run Maximum X-Axis (Media-Axis) PWM: 87
Encoder-Tests Maximum Y-Axis (Carriage-Axis) PWM: 62
Encoder-Tests Maximum X-Axis (Media-Axis) PWM: 62
X-axis Calibration: Amp1 = 7.467, Phase1 = –0.450, Amp2 = 8.956, Phase2 = 2.325, Factor = –0.000500
EEROM CONTENTS
(This is for the Printer design engineers to interpret.)