Filter
Top Products
N1200-320 4Gb Network Storage Router user and service guide 109
C Inband SCSI-3 commands
The HP N1200-320 4Gb Network Storage Router supports a set of SCSI-3 commands that can be
received inband over FCP. When received by the network storage router, these commands are then
executed by the network storage router itself.
When using SCSI-3 commands to access general management features, the commands can be sent to
device LUNs that are mapped through the network storage router.
The following is a list of the SCSI-3 commands that are supported by the network storage router. Complete
definitions of SCSI-3 commands can be found in the SCSI-3 standard available from the American
National Standards Institute (ANSI).
General Commands
• REPORT LUNS
• INQUIRY
General commands
Following is a description of a general-use SCSI-3 command. For more information about the other
general-use commands, please contact your service representative.
Report LUNs command
The network storage router supports the Report LUNs command. The Report LUNs command will return a
list of Logical Unit Numbers (LUNs) that can receive commands. The format of the report LUNs command
is shown in Table 11.
Table 11 Format of Report LUNs command
Bit
Byte
76543210
0Operation Code ( 0xA0)
1Reserved
2Reserved
3Reserved
4Reserved
5Reserved
6(MSB)
Allocation Length
(LSB)
7
8
9
10 Reserved
11 Control Byte